![]() Locate the rubber grommet in the back of the connector (figure 1).ģ. Remove the connector from the alternator. If a wire is present in the “S” position continue with theGroup 2 Installation Instructions for the General Motors Delco CS Alternators on Instructions 180012 or180062.ġ. The purpose of this instruction is to add a sense wire to the harnessPlease Note: If the vehicle’s original equipment plug connector does not have a sense wire in the “S” positionof the original GM connector follow these instructions. This instruction is designed for 1985 and newer GM vehicles equipped with the Delco CSseries alternator, which requires the addition of a sense wire Continue with Group 2 Isolator Installation Instructions for General Motors Delco CS seriesalternators on instruction # 180012 or # 180062.Ī World Leader in Vehicle Electronic Engineering1Ĭonnector Harness ModificationFor Delco CS General Motors Applications Connect opposite end of the new sense wire (insertedin step 6) to the #1 or main terminal of the Battery Isolator.ĩ. Snap lock back into place and insert new connector into thealternator. Any remaining holes should be sealed using rubber plugsprovided in the kit (Figure 6). The new sense wire should mate with the “S” position of the alternatorreceptacle. Verify by looking at the terminal designators on the alternator connectorreceptacle. Insert the new wire and terminal from the kit, into the ”D” (sense) position of the newplug (Figure 5). Repeat this step for all the wires in the connector.Ħ. Makesure the terminal locks into position (Note: some alternators may have more than one wire in the OEM connector). Insert the OEM wire and terminal into the same position of the new connector. This wire will need to go back into the same position of the new connector).Removal of the existing wire can be aided by inserting a small firm wire such as a paper clip into the notched portionof the OEM connector thereby releasing the locking tab.Gently pull the wire and terminal out from the back of theconnector. Remove the existing OEM wire and terminal from the connector (Note which hole the wire occupies. Remove the wire lock from the back of the connector bygently prying back the lock from the tab on each side.(Figure 3) 4. Ifthere is not a wire in the “D” (sense) positionproceed to step 3.ģ. Proceed to the Group 2 Isolator instructions forGeneral Motors (Instruction #180012 or 180062). If there is a wire in the “D”(sense) position, this instruction does not apply. Inspect the connector that plugs into thealternator (Figure 1). If all four terminalsare the same size (as pictured in Figure 1, approximately 1/8th inch wide) proceed tostep 2. If there are three small terminalsand one larger terminal refer to page 2 of this instruction sheet. Unlatch and remove the OEM connector from the alternator and inspect theconnector cavity. The purpose of this instruction is to add a sense wire to the harness.ġ. SPECIAL INSTRUCTIONS FOR DELCO CS 130DThis instruction is designed for 1996 and newer GM vehicles equipped with Delco CS 130Dalternators which require the addition of a sense wire, but the connector is not modifiable ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |